![]() Its heavy, solid ridgid but Im just interested if its worth looking for a replacement even though the raising blocks spread the weight as does th estand and it measures the same as a long bed stand on ebay.Ģ.) The clutch was being investigated when it was dismantled for moving and on taking the black plastic cap off the clutch knob side there was a ball bearing about 3mm to 4mm diameter loose inside. The tailstock though is reinforced either side of the mount point. ![]() the headstock area seems to be reinforced with angle iron about 10mm thick which it is bolted through. ![]() Is this stand dtrong enough for the lathe? It fits with standard long bed deep tray and coolant drain perfectly and does not move at all. ![]() It has the square missing through where the ML8 belt goes through. I have an imacculate myford super 7 at work and while I am quite familiar with them having grown up around one this is a 1980s long bed with power cross feed and gearbox that was acquired refurbished when I joined the company.ġ.) It is on an ML8 stand in green but is lacking the bit ML8s have which the bowl turning attachment fits too and has a deeper front support under the tray with my ford logo as per ML7 stands.
0 Comments
Leave a Reply. |